ZEKOO 5-18 FT Bypass Barn Door Hardware Sliding Black Steel Big Wheel Rolle Hanger

Double track bypass hardware kit offer a smart solution

1. When your wall width did not enough, the bypass system is only need same width with your opening

2. Low ceiling design, only need 9 inch ceiling space from top of the door to ceiling,

3. Can let each barn door silde on each track where you want, the two barn doors slide independently without affecting each other

Package List

4 x 4FT Rail

2 x Track Junction Plate

4 x Steel Hanger with bolt

4 x Door Stopper with Hex Wrench

12 x 1-3/8'' Spacer with lag bolt

6 x Set of Brackets with lag bolt

2 x Floor Guide with screw

4 x Anti-Jumper with screw

1 x Double Track Bypass Barn Door Hardware Installation Manual

About the bearing

• Material quality is high purity bearing steel Gcr15, professional bearing materials, ring fixed structure bearing, wraps around the steel ball and prevent steel ball from leaving the locus, make sliding more stable.
• There is a dust cover the bearing to prevent dust from entering and lubricating oil leakage, letthe roller can slide smoothly and more durable.
• 1 hanger with 2 life time lubricated bearing, ensure sliding balance and stability, test beyond 160,000, you can use it for a long time.

About the hanger

• The roller surface is covered with nylon, wear-resisting and slide very quietly.
• We design the Dowel pin Front part slightly larger, keep the dowel stuck in hole not fall off.
• All of prat is make by Q235 carbon steel, thick is 1/4'' (6.3mm)
• 8 grade roller bolt can hold the doors comfortably

About 8 FT Double track bypass hardware

• Track: 4 piece whole 4ft rails, Pre-drilled 16" apart holes on track, make by solid 1/4" thick steel, with 8.8 grade high strengh bearing capacity lag blots, fit for concrete wall and wooden wall

• Track connector: With 4 screws to fastening the track that make the installation more convenient and beautiful

• Bracket: low ceiling bracket consists of two parts, split design is equal to 2-layer bearing capacity,bring more stable and load-bearing capacity with with 8.8 grade screws

• Track spacer: Provide 1-3/8'' length spacer, fit for door thickness less than 1-3/4", if your door thickness less than 2-1/6 ", we also have 1-3/4'' spacer for you to choose from, If your door thickness is greater than 2-1/6‘’, you can add a headboard on wall, then install the track and bracket

• Door stopper: Prevent the door falling off from the track, one door have 2 stoppers, ensure the stability and safety, with the rubber plug, good damping effect and reduce the noise, have 2 screws to fasten stopper on track, you can put stopper on track where you want to stop your door, easy to remove if you want adjust

• Floor guide: can prevent the door swinging back and forth or against the baseboard, let your door slide on same locus, fit for all thickness with grooved or ungrooved doors

• Anti-jumper: can prevent door to be lifted off rail when the barn door slide, ensure the stability and safety

Double track barn door bypass instructions step by step with fractional measurements in inch, have detailed word instructions with pictures

Installation Notice

1. If you have a doorway trim or your door thickness greater than 2-1/6‘’ or if the studs don't line up with the pre-drilled holes in the rail, you will need to add a headboard.

2. We suggest 1-3/8" ~ 1-3/4" thick door, if you use for other thick door, please tell us, we will provide some accessories to you; And each track limited 230lbs.

3. At least 9" from top of door to ceiling space is required for the double track bypass system to install.

4. This is double track bypass barn door kit, the gap between inner door&wall is about 5/8'' , the gap between two door panels is about 2'' based on door thickness 1-9/16''

5. The distance from the outside door to the wall is about 6‘’

Q&A

Q: How to choose barn door track size?

A: Barn door track length should be at least of total door width. For example, if you each barn doors is 48'' wide, you will need 2*48'' = 96'' （8FT） long track, your opening will show a half, you can use the track which is a little bit longer and please let your door a little bigger than the opening.

Q: Can the bypass barn door system let the opening show fully?

A: Yes, you can select a longer track, if each door is 48'' wide, you can choose 12ft track kit

Q: What accessories is required if I want to install more doors?

A: You can buy an extra set of hangers, we have the hanger sale on shop.

Q: Can i cut the track?

A: Yes, you can cut it into any length of you want

Q: Can i use it for out door ?

A: We suggest if use for outdoors, you can make some cover above the track, and you need paint and add oil regularly to extended service life

Other information